![]() When you first cut the patter you should leave it a little long so it will be able to be tucked under the bottom weatherstrip which will protect it from hitting the bottom edge when rolling the window up and down causing it to peel. You also want to round or square off the corners for the same reason. While tinting the windshield the horn starting going off and wouldnt stop. In the last six months weve run into two cars that it did create a problem. It does help if you have a decent table to work on, trimming will help prevent any rouge edges grabbing the weatherstripping and peeling the tint if you roll the windows up or down. We tint a ton of windshields without much issue. Once you have the pattern cut clean up the edges. There are, however, instances where some people have installed a convertible on their jeep and the window is not tinted. The reason for this is because if you have it backwards you will be making a pattern for the opposite window. A tinted window is the preference of many jeep owners and they are free to use it, depending on the legislation of the state where they reside. For this step you will want to identify which side has the glue (it will be the side that has the clear layer). This material is designed to darken a car’s windows to block UV light and. ![]() ![]() Make sure you squeegee to the edge of the window before you cut or it will be too small and once you cut it there’s no going back. Aftermarket window tinting is a method of applying a thin film to the interior surface of a vehicle’s windows. Now it’s to make the pattern for your window, if you wet the outside of the window and put the tint on it you can make the pattern much easier. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |